DDMI is the Digital Diagnostic Monitoring Interface. DDMI is used to monitor the health of the FLEX24-10G’s fiber optic ports.
Configuration:
FLEX24-10G# configure terminal
FLEX24-10G(config)# ddmi
FLEX24-10G(config)# end
FLEX24-10G# copy running-config startup-config
Building configuration...
% Saving 2188 bytes to flash:startup-config
FLEX24-10G#
By default, DDMI is enabled. When disabled, the
show interface 10GigabitEthernet {1/1 | 1/2} transceiver will produce an error message.
Refer to the Admin Guide for all the advanced settings available in the switch. You’ll find additional resources like the Datasheet, Admin Guide, A&E spec sheet, etc on the product page here.
For more assistance,
|
Comments
0 comments
Please sign in to leave a comment.