How to unjoin TBus Transceivers NV-EC1701/ 1800 series units?

To remove the previous joining association from the TBus 1701/ 1800 series units device memory, do the following:

1. Apply a 56VDC power supply to the transmitter or receiver. No other cables or devices should be connected to the transmitter or receiver.  The Power LED will illuminate blink for 8 seconds and then go on.  The TBus Link LED may also come on, wait up to 20 seconds for it to go out.
2. Using a straightened paper clip. Press and hold the small JOIN button until the Power LED goes off (about 13 seconds)
3. Un-joining is now complete.  The device is now ready to be joined into a new network group.

You’ll find additional resources like the Datasheet, Admin Guide, A&E spec sheet, etc on the product page here.  

For more assistance, 

Create a support ticket here.  Reach us via phone:   1-888-901-3633 [phone]

Reach via chat on our website. Reach us via email here Click here for the Warranty information