How do you un-join or reconfigure the NV-EC1701 transceiver?

To remove the previous joining association from the NV-EC1701 device memory do the following:

1) Connect the 48VDC or 56VDC power supply to the NV-EC1701.  No other cables or devices should be connected to the NV-EC1701. The Power LED will illuminate and the BNC LED may come on during the start-up sequence.  Wait for the BNC LED to go out.

2) Using a straightened paper clip, press and hold the small push button located behind and slightly above the RJ45 LED. Hold the button for about 12 seconds until all LEDs flash. Release the button.  

3) The BNC LED and the Power LED will stay on.  The transceiver is now ready to be joined to a new network group.

You’ll find additional resources like the Datasheet, Admin Guide, A&E spec sheet, etc on the product page here.  

For more assistance, 

Create a support ticket here.  Reach us via phone:   1-888-901-3633 [phone]

Reach via chat on our website. Reach us via email here Click here for the Warranty information