Unidirectional Link Detection (UDLD) is one of the several loop prevention mechanisms contained on the FLEX24-10G. UDLD is configured at the interface level and is used to detect unidirectional links between switches. For a successful UDLD configuration, both the local and remote switch must be UDLD enabled.
There are two UDLD modes:
- Normal Mode
- Aggressive Mode
FLEX24-10G# configure terminal
FLEX24-10G(config)# udld aggressive
FLEX24-10G(config)# udld message time-interval 15
FLEX24-10G(config)# interface GigabitEthernet 1/1
FLEX24-10G(config-if)# udld port aggressive message time-interval 10
FLEX24-10G(config-if)# end
FLEX24-10G#copy running-config startup-config
Refer to the Admin Guide for all the commands to configure ALARM and EVENTS for RMON. You’ll find additional resources like the Datasheet, Admin Guide, A&E spec sheet, etc on the product page here.
For more assistance,
|
Comments
0 comments
Please sign in to leave a comment.