How do I configure RMON (Remote Network Monitoring) on the NVT Phybridge FLEX24-10G (NV-FLX-024-10G) switch?

Remote Monitoring allows the specific aspects of the switch to be monitored. Alerts can then be raised when a certain threshold is reached. When an alarm has been raised an event can be triggered in the form of an SNMP trap, SYSLOG log, or both.

RMON configuration consists of two steps

• ALARM configuration
• EVENT configuration 

Both statistics and alarm entries are created from Interface Configuration mode as follows: 

FLEX24-10G# configure terminal
FLEX24-10G(config)# interface GigabitEthernet 1/1
FLEX24-10G(config-if)# rmon collection stats 1
FLEX24-10G(config-if)# end
FLEX24-10G# copy running-config startup-config
Building configuration...
% Saving 2230 bytes to flash:startup-config
FLEX24-10G#

Refer to the Admin Guide for all the commands to configure ALARM and EVENTS for RMON. You’ll find additional resources like the Datasheet, Admin Guide, A&E spec sheet, etc on the product page here.  

For more assistance, 

Create a support ticket here.  Reach us via phone:   1-888-901-3633 [phone]

Reach via chat on our website. Reach us via email here Click here for the Warranty information